timex expedition indiglo wr50m replacement band

Your symptoms are to me that the watch needs to be let down and a service given, basically the mainspring is fully wound but something is stopping the power from the mainspring to be transmitted through the train to the balance, so a little detective work into required to find out what! When you get to the hairspring you will have unpinned it during the strip down, now you will have to re pin the hairspring, beware you will ping the small brass taper pin into another universe to begin with until you get the hang of it.Īs for the hands, all watch hands can be a bit of a pain until you have done a few, but with the correct tools it's pretty easy ok.Īlso the tabs you mention are I believe dial tabs, theses are holding the dial on, the movement is held together by 4 screws, which screw into 4 pillars that hold the plates the correct width apart. The way to do it is to start with the furthest wheel away from you and with seriously light pressure to hold the plates together between your finger and thumb use an oiler to manipulate each wheel in turn into their respective jewels. Mate the timex movements are pretty easy to work on, the hardest part is putting the plates together, unlike other movements that have bridges, one for the barreL one for the train a cock for the balance and a tiny bridge for the fork, on these timex movements you have two plates and you have to line up the train the barrel the balance and the fork all at once. With regards to the movement It is mechanical however it's very very basic, it's held together with tabs, I think a watch maker would laugh at me, I am comfortable with replacing the movement I can pick a watch up for five pounds, if I have a spare I will try and get this one working with no risk if I can't repair it. I think it most likely just needs a cleaning of the inner components and re-lubricating.Ĭheers Chopin, never though of polishing it, I will give it a go. Is your watch mechanical ? If yes then you can simply take it to a watchmaker and get it serviced. One thing you have to be careful is that you'll have to put some tape on the face of the watch so as not to polish the case as that might make the finish uneven.įor your second issue. You simply put some polywatch on the crystal and then with a small piece of rag or a tissue you have to do circular and even motions (in both directions). You can use Polywatch which is a substance made specially for this (costs 5-6$) or you can use toothpaste which apparently acts the same thing. If it has no cracks and the scratches aren't very deep you can actually polish it yourself. The glass is, I'm assuming, acrylic crystal which is basically a thick transparent plastic.

Timex expedition indiglo wr50m replacement band